E404; E405; E410 - Canon DADF-Q1 Service Manual

ADF controller PCB
5) Try replacing the belt motor driver PCB. Is the problem corrected?
YES: Replace the belt motor drive PCB.
NO: Replace the ADF controller PCB.

4.4.1.2 E404

1) Set the DIP switch (SW1) on the ADF controller PCB as indicated.
Does the delivery motor (M5) rotate when the push switch (SW2) is pressed?
(To stop the operation, press the push switch (SW2) once again.)
YES: Go to step 3).
Delivery motor (M5)
2) Does it become good if the delivery motor is exchanged?
YES: End.
NO: Go to the next step.
After replacing the delivery motor, be sure to perform "Adjusting the Sensors and the Delivery Motor."
Delivery Motor Clock Sensor (PI11), ADF Controller PCB
3) Set the meter range to 10 VDC. Does the voltage between connectors J3-2 (+) and J3-1 (-) on the ADF controller PCB alternate between 0 and 5 V when the
delivery motor is rotated by hand?
NO: Replace the delivery motor clock sensor (PI11).
YES: Replace the ADF controller PCB.

4.4.1.3 E405

1) Set the DIP switch (SW1) on the ADF controller PCB as indicated.
Does the separation motor (M4) rotate when the push switch (SW2) is pressed?
(To stop the operation, press the push switch (SW2) once again.)
YES: Go to step 3).
Separation motor (M4)
2) Disconnect the connector (J8) of the ADF controller PCB. Set the meter range to x1 ohm, and connect the meter probe to the connectors on the cable side as
indicated. Is the resistance about 5.0 ohm?
NO: Replace the separation motor (M4).
Separation motor clock sensor (PI2), ADF controller PCB
3) Set the meter range to 10 VDC. Does the voltage between connectors J12-5 (+) and J12-4 (-) on the ADF controller PCB alternate between 0 and 5 V?
NO: Replace the separation motor clock sensor (PI2).
YES: Replace the DADF controller PCB.

4.4.1.4 E410

1) Set the DIP switch (SW1) on the ADF controller PCB as indicated.
Does the motor (M3) rotate when the push switch SW2 and then the push switch SW3/SW4 are pressed?
(To stop the operation, press the push switch (SW2) once again.)
YES: Go to step 3).
Pickup motor (M3)
2) Does it become good if the pickup motor is exchanged?
YES: End.
NO: Go to the next step.
F-4-149
F-4-150
F-4-151
F-4-152
Chapter 4
0011-3665
0011-3666
0011-3667
4-31