Removing The Delivery Roller - Canon DADF-Q1 Service Manual

[2]
3) When you have removed the ADF controller cover, disconnect the con-
nector [3] of the ADF controller PCB; then, remove the screw [4], and re-
move the grounding wire [5]. Free the harness from the wire saddle [6],
and detach the other saddle [7].
Push.
4) Remove the four screws [1], and detach the main cover [2].
The main cover is fitted with the original tray [3], and cables are connected
to it. Take extra care when removing it not to damage the cables.
[1]
[2]
Hooks
F-3-130
[7]
Freed.
[5]
[4]
[6]
[3]
F-3-131
[1]
[3]
[1]
[1]
F-3-132

3.4.5.4 Removing the Delivery Roller

1) Remove the screw [1] from the bottom of the DADF, and remove the bear-
ing [2] and the rod [3].
[2]
2) Remove the four screws [1], and detach the hinge (right) [2].
[1]
[1]
3) Remove the E-ring [1], and detach the solenoid link arm [2].
4) Remove the screw [1], and detach the delivery guide plate [2].
5) Remove the screw [3], and free the grounding wire [4] of the static
eliminator attached to the delivery guide.
6) Remove the three screws [1], and disconnect the connector [2]; then, de-
tach the solenoid unit [3] from the delivery assembly front side plate.
Chapter 3
[3] [1]
F-3-133
[2] [1]
[1]
[1]
F-3-134
[1] [2]
F-3-135
[4] [3]
[1] [2]
F-3-136
0011-2487
3-19