Control Panel; Covers - Permobil Street Service Manual

Covers

Removal of front cover
The cover is attached with a guide pin at each side
and hook and loop fastener at the front edge; see
figure.
1. Run/fold out the leg rests, and if possible, raise
the seat elevator.
2. Turn off the main power switch on the control
panel.
3. Press the cover's sides inwards at the shock
absorbers' rear brackets while pulling the
cover forward.
4. With the wheel lock release lever at a middle
position, detach the cover at the lower edge by
pulling it straight forward.
Fitting
Fitting is the reverse procedure.
Removal of rear cover
The rear cover is attached with two guide pins at
the back edge and with hook and loop fastener on
the inside; see figure.
1. Chair with seat elevator:
Raise the seat to its highest position; turn off
the main power switch on the control panel. If
the seat elevator cannot be raised because of
a fault other than to the seat elevator, it can be
raised manually; see page 28.
Chair with fixed seat post:
Raise the seat to its highest position, see
page 31.
Chair without seat elevator / fixed seat post:
If the chair is not equipped with a seat
elevator, remove the seat; see page 28.
2. Pull the cover's rear edge straight back so that
the guide pins disengage; then lift up so that
the hook and loop fastener on the inside of the
cover releases.
NOTE
If the chair is equipped with lighting, disconnect the rear-light
cabling at the connector fitted on the cabling.
Fitting
Fitting is the reverse procedure.
Front cover attachment points.
Rear cover attachment points.
7
Covers