Page 3
Introduction This user manual covers the functions of your ICS seat control panel and is intended as an extension to your power wheelchair’s user manual. Please read and follow all instructions and warnings in all manuals supplied with your power wheelchair and its accessories. Incorrect use may both injure the user and damage the wheelchair.
Page 4
Text Produced and published by Permobil Edition: 1 Date: 2019-12-16 Order no: 336632 eng-UK...
Page 5
Regus 6th floor 2 Kingdom Street Email: info@permobil.uk Paddington W2 6BD London United Kingdom Head office of the Permobil group Permobil AB Per Uddéns väg 20 SE 861 36 Timrå Sweden +46 60 59 59 00 Tel.: Fax: +46 60 57 52 50 Email: info@permobil.com...
ICS seat Warnings 1 Warnings WARNING! Environmental conditions Protect the wheelchair from exposure to any type of moisture, including rain, snow, mud or spray. If any of the covers or the joystick boot has cracks or tears, it must be replaced immediately.
ICS seat ICS seat control panel 2 ICS seat control panel General The seat’s powered functions may be controlled from the drive system control panel. On seats equipped with the control system ICS, the powered functions may also be controlled from the ICS control panel.
ICS seat ICS seat control panel 2.1.1 Feedback The control panel provides feedback regarding the available seat functions, active seat function inhibits, active drive speed limits and active drive inhibits through its LEDs. The LED above the switch can assume three states: 1.
ICS seat ICS seat control panel • A flashing yellow LED means the seat function is inhibited in one direction, due to a safety limit. The switches below the icon will only move the seat in the safe direction. • A flashing red LED means an actuator error has been detected.
ICS seat ICS seat control panel 2.2.1 Seat lift The seat can be raised by pressing the upper part of the button and lowered by pressing the lower part. Figure 2. Seat lift. 2.2.2 Backrest angle The backrest can be reclined by pressing the lower part of the button and brought back by pressing the upper part.
ICS seat ICS seat control panel 2.2.4 Forward tilt The seat can be tilted forward by pressing the upper part of the button and backward by pressing the lower part. When the seat is being tilted forward or backward, the seat will stop when it reaches neutral position.
ICS seat ICS seat control panel 2.2.7 Seat-to-floor function The seat can be lowered to the floor by pressing the upper part of the button, and raised by pressing the lower part. Figure 8. Seat to floor function. 2.2.8 Standing function The seat can be raised to standing position by pressing the upper part of the button, and lowered to sitting position by pressing the lower part.
ICS seat ICS seat control panel 2.2.9 Power footplates The footplates can be raised by pressing the lower part of the button and lowered by pressing the upper part. Figure 10. Power footplates. 2.2.10 Power transfer The footplate can be lowered at the same time as the seat lift is raised by pressing the upper part of the button.
ICS seat ICS seat control panel 2.2.12 Memory function ICS control panels equipped with memory can store and recall up to three seat positions. A seat function (e.g. power tilt, power recline, power legs, etc.) can only memorise a position if it has an actuator with position feedback installed.
Page 19
ICS seat ICS seat control panel 2.2.12.2 Storing memory Before storing a seating position in the memory, configure the seat system in the desired position. 1. Enter memory mode by pressing and holding the memory button (8) for two seconds. While in the memory mode, the LED flashes green.