Front Wheels - Permobil Street Service Manual

Front wheels

Front wheels
Removal
1. Turn off the main power switch on the control
panel.
2. Lift the wheelchair chassis and support it on
blocks so that the wheel is off the ground.
3. Remove the hubcap (1), bolt (2) and washer
(3); see figure.
Fitting
1. Check that the wheel shaft and rim are
undamaged. Clean as necessary to remove
dirt and rust. Replace damaged parts.
2. Slide the wheel onto the shaft using hand force
only. Ensure that the wheel bottoms on the
shaft.
3. Mount the washer (3) onto the bolt (2) and
secure the wheel. Use a torque wrench to
tighten the bolt to 17.7 ft-Ibs (24Nm).
Install the hub cap (1). See Fig.
NOTE
The bolt must be used once only. Removed bolt is not
allowed to be refitted.
WARNING
Other types of bolts or washers are not to be used.
WARNING
Other types of locking coatings or fluids may not be used.
Front wheel: 3.00"-4"
Pos.
1 Hubcap
2 Bolt, ISO 4017 M8x25 8.8 Fe/Zn 5 C1 / LOCKING
COAT DIN 267-28
3 Washer, SS 1466 TBRSB 8.4x26x5 HB305 Fe/Zn 5 C1
4 Front wheel(Right) 3.00"-4" Air
Front wheel(Left) 3.00"-4" Air
Description
1 2 3
Fitting of rim.
Front wheel: 210x65
Pos.
1 Hubcap
2 Bolt, ISO 4017 M8x16 8.8 Fe/Zn 5 C1/ LOCKING
COAT DIN 267-28
3 Washer, 8.5x23x3
4 Front wheel, 210x65
Front wheel, 210x65
12
Front wheel
4
Description
Air
Solid