Lights (Accessorie) - Permobil Street Service Manual

Lights
Lights
(accessory)
Removing the front lights
1. Switch off the main power switch on the control
panel.
2. Remove the front chassis cover. See page 7.
3. Chock up the chair so that the front wheel on
the relevant side is freely suspended.
4. Unscrew and remove the screw with which the
shock absorber and the light are fitted to the
chassis. See the picture.
5. Unscrew and remove the other screw with
which the light is fitted. See the picture.
6. Cut off the cable ties that hold the cables.
7. Divide the light's cables at the contact on the
cables. This is loose inside the chassis.
Installation
Install the lights in the reverse order.
Replacing a bulb
1. Switch off the main power switch on the control
panel.
2. Unscrew and remove the two screws that hold
the light's insert. Remove the insert. See the
picture.
3. Remove the bulb holder by pulling it straight
out. Replace the bulb.
4. Reinstall in the reverse order.
The light's insert is fitted with two screws.
38
The light is fitted with two screws. The upper
screw also holds the shock absorber.
The light's insert and bulb holder.Fig. 78. The
light's insert and bulb holder.