Wheel Lock Release Sensor - Permobil Street Service Manual

Wheel lock release sensor

Wheel lock release sensor
Removal
1. Remove the chassis cover; see page 7.
2. Put the circuit breaker in the "OFF" position;
see page 35.
3. Remove the wheel lock release mechanism;
see page 20.
4. Remove the wheel lock release sensor, which
is attached with two screws.
NOTE
If the release sensor is replaced, its connection cables must
be re-soldered.
Fitting
Fitting is the reverse procedure.
Wheel lock release sensor.
Pos.
1 Wheel lock release sensor, VK08N001A
2 Bolt, ISO 4017 M3x20 8.8 Fe/Zn 5 C1
3 Washer, ISO 7089 3 200 HV Fe/Zn 5 C1 (3,2x7x0,5)
4 Nut, DIN 985 M3 6 Fe/Zn 5 C1
22
Description