Permobil Street Service Manual page 29

Seat elevator
Chair without seat tilt
1. Put the circuit breaker in the "OFF" position;
see figure.
2. Remove the four screws on the seat frame
bottom that secure the seat frame's lower
section; see figure.
3. Lift off the seat and place it on its side beside
the chassis.
NOTE
Because the seat is heavy, it should be lifted by two persons. Be
careful with the cabling.
4. Remove the part of the seat frame that
remains on the seat elevator/seat column. It is
attached with four screws; see figure.
Fitting
Fitting is the reverse procedure.
Circuit breaker/Battery isolator.
1
Seat elevator and seat frame.
29
Seat elevator
1
2