Filling With Air - Permobil Street Service Manual

Front wheel with air
Byte av innerslang
1. Turn off the main power switch on the control
panel.
2. Lift the wheelchair chassis and support it on
blocks so that the wheel is off the ground.
3. Remove the wheel, see page 12.
4. Let the air out of the tire.
5. Remove the bolts with nuts thats holds the
inner and outer part s of the rim together, see
figure below.
6. Remove the broken inner tube.
7. Fit a new inner tube in the tire.
8. Refit the rim parts, fit the outer part with the
innertubes valve throu the hole, see fig.
Assemble the rim with the tire, making sure the
tube doesn't get trapped between the two
halves of the rim
9. Refit the bolts with nuts.
10. Fill the tire with air, see below.

Filling with air

Check at regular intervals that the wheelchair's tires have the prescribed tire pressure. An incorrect tire
pressure can cause deterioration in stability and manueverability, plus extremely low air pressure can give
rise to abnormal wear as well as shorter driving distances. So check regularly to see that the tires are
maintained at a pressure of 36 psi (250 kPa).
1. Unscrew the plastic cap on the air valve of the tire.
2. Connect the compressed air nozzle to the air valve and adjust the tire pressure to the prescribed level.
VARNING
The recommended air pressure for front/rear tires is 36 psi (250 kPa). Overfilling causes a risk of explosion. Incorrect tire pressure
can involve a deterioration of stability and manueverability, so check regularly that the tire contains the prescribed air pressure.
If the wheel bolt is removed for tire service, replace it with a new, unused part from Permobil and tighten the bolt to the
recommended torque. Also, inspect the drive axle and wheel rim for any damage. Damage to either part can cause the wheel bolt
to loosen or fracture. Permobil recommends that wheel bolts be used only one time.
Filling Valve, front wheel.
Front wheel, 210x65, Air
Front wheel, 3.00"-4", Air
13
Front wheels