Wheel Lock Release Sensor - Permobil K300 Service Manual

Wheel Lock Release
Removing the wheel
lock release sensor.
1. Raise the seat; seat elevator to the highest
position; fixed seat tube to the service position.
See page 24. If the seat elevator does not work
normally because the batteries are discharged
or the actuator is defective, the seat can be
raised/lowered manually. See page 22.
2. Switch off the main power switch on the control
panel.
3. Remove the chassis cover. See page 8.
4. Disconnect the electrical connection of the
wheel lock release sensor, it´s positioned on the
top of the front battery.
5. Remove the wheel lock release sensor. It is
fitted with two screws. See figure.
6. Remove the plate fitted on the wheel lock
sensor. It is fitted with two screws and nuts.
Fitting the Wheel Lock Release Sensor
Fit the wheel lock release sensor in the reverse
order.

Wheel lock release sensor.

22
Wheel lock release sensor
is fitted with two screws.