Configuring Mpbgp; Figure 24 Configuring Ebgp Between Ce And Pe - Zte ZXR10 8900 Series User Manual

St- Command
ep
1
router bgp <as-number>
ZXR10(config)#
2
ZXR10(config-router)#
remote-as <as-number>
3
ZXR10(config-router)#
activate
4
ZXR10(config-router)#
update-source loopback<1-64>
F 24 C
IGURE ONFIGURING
Configuration on CE1:
CE1(config)#router bgp 65001
CE1(config-router)#redistribute connected
CE1(config-router)#neighbor 10.1.0.2 remote-as 100
CE1(config-router)#neighbor 10.1.0.2 activate
Configuration on PE1:
PE1(config)#router bgp 100
PE1(config-router)#address-family ipv4 vrf vpn_a
PE1(config-router-af)#neighbor 10.1.0.1 remote-as 65001
PE1(config-router-af)#neighbor 10.1.0.1 activate
PE1(config-router-af)#redistribute connected

Configuring MPBGP

To configure MPBGP, perform the following steps.
neighbor <ip-address>
neighbor <ip-address>
neighbor <ip-address>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 MPLS L3VPN Configuration
EBGP CE
BETWEEN AND
Function
This enters BGP route
configuration mode
This configures a BGP
neighbor
This activates a neighbor
This configures the source
address of updated route
PE
43