Figure 31 Vpls Configuration Example 2 - Zte ZXR10 8900 Series User Manual

ZXR10 8900 Series User Manual (MPLS Volume)
F 31 VPLS C
IGURE ONFIGURATION
60 Confidential and Proprietary Information of ZTE CORPORATION
P(config-if)#ip address
P(config-if)#mpls ip
P(config-if)#exit
P(config)#mpls ip
P(config)#mpls ldp router-id loopback10 force
P(config)#router ospf 1
P(config-router)#network 1.1.1.2 0.0.0.0 area 0.0.0.0
P(config-router)#network 148.1.1.0 0.0.0.255 area 0.0.0.0
P(config-router)#network 175.1.1.0 0.0.0.255 area 0.0.0.0
PE2 configuration:
PE2(config)#vfi vpls_a
PE2(config-vfi)#vcid 100
PE2(config-vfi)#pwtype ethernet-vlan
PE2(config-vfi)#peer 1.1.1.1
PE2(config)#interface gei_1/5
PE2(config-if)#switch access vlan 40
PE2(config-if)#exit
PE2(config)#interface gei_1/6
PE2(config-if)#switch access vlan 200
PE2(config-if)#exit
PE2(config)#interface gei_1/7
PE2(config-if)#switch access vlan 300
PE2(config-if)#exit
PE2(config)#interface loopback10
PE2(config-if)#ip address
PE2(config)#interface vlan 40
PE2(config-if)#ip address
PE2(config-if)#mpls ip
PE2(config)#interface vlan 200
PE2(config-if)#xconnect vfi vpls_a
PE2(config-if)#exit
PE2(config)#interface vlan 300
PE2(config-if)#xconnect vfi vpls_a
PE2(config-if)#exit
PE2(config)#mpls ip
PE2(config)#mpls ldp router-id loopback10 force
PE2(config)#mpls ldp target-session 1.1.1.1
PE2(config)#router ospf 1
PE2(config-router)#network 1.1.1.3 0.0.0.0 area 0.0.0.0
PE2(config-router)#network 148.1.1.0 0.0.0.255 area 0.0.0.0
Suppose that networking in
Figure 31, a CE4 is connected to P so that CE1, CE2, CE3 and CE4
are in the same VFI. In the networking, P can also be configured
to a PE (PE3).
E 2
XAMPLE
PE1 configuration:
148.1.1.2 255.255.255.0
1.1.1.3 255.255.255.255
148.1.1.3 255.255.255.0
Figure 30 is changed. As shown in