Figure 32 Vpls Configuration Example 3 - Zte ZXR10 8900 Series User Manual

Chapter 4 MPLS L2VPN Configuration
PE1(config)#vfi vpls_a
PE1(config-vfi)#peer 1.1.1.2
P (PE3) configuration:
P(config)#vfi vpls_a
P(config-vfi)#vcid 100
P(config-vfi)#pwtype ethernet-vlan
P(config-vfi)#peer 1.1.1.1
P(config-vfi)#peer 1.1.1.3
P(config)#interface gei_1/8
P(config-if)#switch access vlan 400
P(config-if)#exit
P(config)#interface vlan 400
P(config-if)#xconnect vfi vpls_a
PE2 configuration:
PE2(config)#vfi vpls_a
PE2(config-vfi)#peer 1.1.1.2
In the two networking modes in Figure 30, and in Figure 31, the
flat VPLS network is inside the MPLS network. PWs connecting PEs
in a VPLS instance are HUB PWs.
When a new PE is added into the VPLS instance, no PW needs to be
established between the PE and other PEs. As shown in Figure 32,
PE10 and PE 20 only establish PW relationship with P (also called
PE3). They do not need to establish PW relationship with PE1 and
PE2. This PW type is called SPOKE PW.
F 32 VPLS C E 3
IGURE ONFIGURATION XAMPLE
Router IDs of PE10 and PE20 are 1.1.1.10 and 1.1.1.20. Configu-
ration is as follows.
P (PE3) configuration:
P(config)#vfi vpls_a
P(config-vfi)#peer 1.1.1.10 spoke
P(config-vfi)#peer 1.1.1.20 spoke
Confidential and Proprietary Information of ZTE CORPORATION 61