Configuring Mpls L3Vpn; Configuring Ospf In Mpls Domain; Figure 19 Configuring Ospf In Mpls Domain - Zte ZXR10 8900 Series User Manual

St-
Command
ep
1
ZXR10(config)#
2
ZXR10(config-router)#
ild-card> area <area-id>
Example
F 19 C
IGURE ONFIGURING
� According to IP address (source IP, destination IP and
source+destination IP)
� According to label (public network label, private network, pub-
lic+private network label)
ZXR10 8900 series switch can support up to 32 Smartgroups.
There are up to 8 ports in each Smartgroup. Balance efficiency
ratio can reach 100%. The convergence time is within 600ms.

Configuring MPLS L3VPN

Configuring OSPF in MPLS Domain

To configure OSPF in a MPLS domain, perform the following steps.
router ospf <process-id>
network <network-number><w
This example describes how to configure OSPF as IGP in a MPLS
domain.
As shown in Figure
OSPF MPLS D
IN OMAIN
Configuration on PE1:
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 MPLS L3VPN Configuration
Function
This starts OSPF process
This enables OSPF on an
interface
19, configure OSPF on PE1, P and PE2.
35