Zte ZXR10 8900 Series User Manual page 63

St- Command
ep
1
netcard vpn
ZXR10(config)#
2
mac learn special
ZXR10(config)#
3 vfi <vfi-name>
ZXR10(config)#
4
ZXR10(config-vfi)#
5
ZXR10(config-vfi)#
ethernet-vlan}
6
ZXR10(config-vfi)#
7
ZXR10(config-if)#
8
mpls ldp target-session
ZXR10(config)#
<peer-ip-address>
vcid <vcid>
pwtype { ethernet |
peer <peer-ip-address>[spoke]
xconnect vfi <vfi-name>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 4 MPLS L2VPN Configuration
Function
This configures micro code
version. It is required to
reboot line interfaces with
network processor after this
command is configured.
When this command is saved,
reboot the rack instead of line
interfaces.
This configures MAC address
study mode.
This creates VFI and enters
VFI configuration mode.
This configures vcid. when
VPLS instances of two PE
routers belong to same VPLS
region, it is required to
establish PW to continue the
communication between VPLS
instances. PE establishes PW
to identify mpls lining-label
(or called VC label. Mpls
outer-label, which compose
lsp, together with VC label,
compose the PW) of VPLS
region with each other. Vc-id
configured by vcid is used to
identify the VPLS region when
PE changes VC label.
This configures pwtype
parameter. Two PEs need
to negotiate PW type when
they establish PW. There
are two types of PWs in
VPLS which are ethernet
and ethernet-vlan. When
PW types are different with
each other, PW can not be
established.
This configures peer
parameters. It is required to
designate all PE addresses in
one VPLS region. Spoke type
is used to bed VPLS and span
regions.
This starts VPLS configuration
on L3 interface.
This configures expanding
LDP neighbor. VPLS module
function is based on LDP
protocol. To establish PW
between indirect PEs, it is
important to establish LDP
neighbor through switching
TARGET HELLO of LDP, and
then distribute label of PW.
55