Frame-Relay Map; Frame-Relay Switching - Zte ZXR10 Command Manual

ZXR10 Command Manual (Remote Access Volume)
Function
Command Mode
Syntax
Syntax
Description
Instructions
Example
Related Command
Function
Command Mode
Syntax
Default
Instruction
24 Confidential and Proprietary Information of ZTE CORPORATION

frame-relay map

Use this command to define the mapping between the destination
protocol address and DLCI. DLCI is used to connect the destination
address. Cancel the mapping with the no form of this command.
Interface configuration
frame-relay map ip <ip-address><dlci>[<encap>]
no frame-relay map ip <ip-address>
ip
<ip-address>
<dlci>
<encap>
� It is only applied to ZXR10 GAR and ZXR10 ZSR.
� The IP address should be the IP address of the peer.
� Suppose that the IP address of the interface of a peer router
is 2.2.2.2, DLCI is 301, and then set the mapping relation as
follows.
ZXR10(config-if)#frame-relay map ip 2.2.2.2 301
� Suppose that the IP address of the CISCO interface of a peer
router is 2.2.2.2, DLCI is 301, and then set the mapping rela-
tion as follows.
ZXR10(config)#interface e1_1/1.1
ZXR10(config-if)#frame-relay map ip 2.2.2.2 301 cisco
show frame-relay map

frame-relay switching

Use this command to enable the setting of the frame-relay equip-
ment type. Disable the setting with the no form of this command.
Global configuration

frame-relay switching

no frame-relay switching
Disable
It is only applied to ZXR10 GAR Version 2.2.
IP protocol
IP address in dotted decimal format
DLCI value, in the range of 16~1007
Encapsulation mode, ietf or cisco, default: ietf