Qos Cos-Drop-Map - Zte ZXR10 Command Manual

ZXR10 Command Manual (QoS Volume)
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
12 Confidential and Proprietary Information of ZTE CORPORATION
<cos6-value>
<cos7-value>
The default value is 0.
� The platform version 4.6.02 and upgrade versions support this
command.
� It is applied to ZXR10 3900/3200.
� This mapping table is employed when the switch performs re-
mark (traffic-limit) for the packet service parameters:
When the traffic-limit command is used to monitor the data
flow and the conform remark-cos is configured, the switch
will use the relevant mapping table to mark the data flow
802.1P user priority parameter based on the packet local
priority and data flow through the conformance level (green,
yellow or red) determined by three-color mark algorithm.
This example describes how to configure conform-local.
ZXR10(config)#qos conform-local green 0 1 2 3 4 5 6 7
show running-config
show qos-conform-local

qos cos-drop-map

Use this command to set the mapping table between the 802.1P
user priority and the switch local drop precedence.
Global configuration
qos cos-drop-map <cos0-value><cos1-value><cos2-value><c
os3-value><cos4-value><cos5-value><cos6-value><cos7-val
ue>
no qos cos-drop-map
<cos0-value>
<cos1-value>
<cos2-value>
<cos3-value>
<cos4-value>
802.1P user priority corresponding to the
local priority 6, range: 0~7
802.1P user priority corresponding to the
local priority 7, range: 0~7
The corresponding drop precedence when cos
is 0, range: 0~2
The corresponding drop precedence when cos
is 1, range: 0~2
The corresponding drop precedence when cos
is 2, range: 0~2
The corresponding drop precedence when cos
is 3, range: 0~2
The corresponding drop precedence when cos
is 4, range: 0~2