Frame-Relay Lmi-T392Dce; Frame-Relay Lmi-Type - Zte ZXR10 Command Manual

frame-relay lmi-t392dce

Use this command to set the query acknowledgement timer dura-
Function
tion of the DCE or NNI interface. Restore default with the no form
of this command.
Interface configuration
Command Mode
frame-relay lmi-t392dce <seconds>
Syntax
no frame-relay lmi-t392dce
Syntax
Description
This value must be larger than the keep-alive timer value of the
Default
DTE/NNI at the peer end.
It is only applied to ZXR10 GAR and ZXR10 ZSR.
Instructions
This example describes how to set the t392 value of dce as 20.
Example
ZXR10(config)#interface e1_1/1.1
ZXR10(config-if)#frame-relay lmi-t392dce 20

frame-relay lmi-type

Use this command to set the FR lmi type. Restore the default with
Function
the no form of this command.
Interface configuration
Command Mode
frame-relay lmi-type <lmi-type>
Syntax
no frame-relay lmi-type
Syntax
Description
�
Instructions
�
�
This example describes how to set the frame-relay lmi type to ansi.
Example
ZXR10(config)#interface e1_1/1.1
ZXR10(config-if)#frame-relay lmi-type ansi
<seconds>
<lmi-type>
The no command enables the auto-detection function of frame-
relay lmi. The FR DTE sends an lmi detection packet to the peer
DCE, to obtain the lmi type of the peer equipment and set it
as its own lmi type.
When the interface protocol status is down or its encapsulating
protocol is changed to FR, the lmi self-detection function will
also be enabled if the lmi-type parameter is not configured. If
the protocol is in up status, the lmi self-detection packet will
not be sent.
It is only applied to ZXR10 GAR and ZXR10 ZSR.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 4 Frame Relay Protocol
Value of the query acknowledgement timer, in
seconds, in the range of 5~30, default: 15
seconds
Name of lmi type, it may be ansi, cisco or
q933a, default: q933a
23