Frame Relay Protocol; Frame-Relay Interface-Dlci - Zte ZXR10 Command Manual

Function
Command Mode
Syntax
Syntax
Description
Instruction
Example
Related Command
4
C h a p t e r

Frame Relay Protocol

Table of Contents
frame-relay interface-dlci ...................................................19
frame-relay interface-mode ................................................20
frame-relay intf-type..........................................................20
frame-relay lmi-n391dte.....................................................21
frame-relay lmi-n392dce ....................................................21
frame-relay lmi-n392dte.....................................................21
frame-relay lmi-n393dce ....................................................22
frame-relay lmi-n393dte.....................................................22
frame-relay lmi-t392dce .....................................................23
frame-relay lmi-type ..........................................................23
frame-relay map ...............................................................24
frame-relay switching.........................................................24
show frame-relay lmi .........................................................25
show frame-relay map .......................................................25
show frame-relay pvc.........................................................26

frame-relay interface-dlci

Use this command to define the DLCI of the current interface in
point-to-point mode.
Interface configuration
frame-relay interface-dlci <dlci>
no frame-relay interface-dlci
<dlci>
This command is effective only in Frame-Delay point-to-point
mode
This example describes how to set the interface DLCI to 100.
ZXR10(config-if)#frame-relay interface-dlci 100
frame-relay interface-mode
Confidential and Proprietary Information of ZTE CORPORATION
DLCI value of the interface
19