Setup Sony Bve; Interfacing The Bve 2000 - TAMUZ HCM 112 Operation Manual

Individual Adjustments and Setups

Setup SONY BVE

When the Sony BVE editors sends his non-standard information, the GOLDEN EAGLE series inter-
face detects it automatically. To adjust that signals correctly, use the default values or make you indivi-
dual adjustments, see tables below.
The default setup carried out, that the image of the BVE signal fits at the best to the screen.
BVE signals at VGA input port for HCM 113 / 115:
Signal Format
BVE 9000
BVE 2000
BVE signals at VGA input port for HCM 117 / 120:
Signal Format
BVE 9000
BVE 2000

Interfacing the BVE 2000

The VDU output at the BVE is made as a 9pin Sub-DF connector and a special cable is needed for the
connection to the monitor. Use a high-quality single shielded 75 Ohms multiple coax-cable for this
special interconnection.
The pin-out of the cable Sub-HD15M to Sub-D9M port is shown in following table:
Pin @
Function @ Monitor
HD15M
1 R Video
2 G Video
3 B Video
4 not connected
5 not connected
6 Ground R Video
7 Ground G Video
8 Ground B Video
Leave all not named pins at the Sub-D9M open.
© 02.07 TAMUZ - LCD Video Monitors
GEOMETRY SETTINGS INPUT
Pixel
Clock / Phase X-Position
MHz
42.57 16 -85
85.96 16 -62
GEOMETRY SETTINGS INPUT
Pixel
Clock / Phase X-Position
MHz
42.57 16 -85
85.96 16 -62
Pin @ D9M Function @ BVE Editor
3
4
5
1
1
1
Y-Position Pixel Lines
-4 1920 262
-7 1920 526
Y-Position Pixel Lines
-4 1920 262
-7 1920 526
Pin @
HD15M
R Video 9
G Video 10
B Video 11
12
13
Ground 14
Ground 15
Ground Shield
HCM Series Broadcast Monitor
GOLDEN EAGLE
GEOMETRY SETTINGS DISPLAY
Interlace Pixel Lines
No 1024 768
No 1024 768
GEOMETRY SETTINGS DISPLAY
Interlace Pixel Lines
No 1280 1024
No 1280 1024
Function @ Monitor Pin @ D9M
not connected
Ground Sync 1
not connected
not connected
Composite Sync 8
not connected
not connected
Ground Shield
X-Position Y-Position
0 0
0 0
X-Position Y-Position
0 0
0 0
Function @ BVE Editor
Ground
Composite Sync
! not connected !
Page - 96 -