Frequently Asked Questions; Tamuz - Lcd Video Monitors Hcm Series Broadcast Monitor - TAMUZ HCM 112 Operation Manual

Frequently Asked Questions

Frequently Asked Questions
When the user needs help to operate the monitor or in case of malfunction, check these FAQ listing to
find an answer first.
Q: I can't see color images on screen, but the switch B/W is set to color?
A: Check the adjustment control COLOR or turn the pot in a mid position.
Q: There is no signal at the loop connector, when the monitor is switched off?
A: All loop-through ports at the Eagle series are active loops and works only when the monitor
is powered.
Q: At my GOLDEN EAGLE monitor the image on screen is turned 180°. What is wrong?
A: The feature switch REVERSE is set to REVERSE. Switch back to NORMAL and the monitors
works in the normal mode again.
Q: During outside production my GOLDEN EAGLE monitor becomes dirty. Can i clean the
monitor with water?
A: The housing is protected against fluids. To clean the monitor it is a better choice to use
usual gentle glass cleaner and soft cotton cloths. No acids or solvent may be used for
cleaning.
Q: The GOLDEN EAGLE monitor don't reacts to any command from the IR-Remote Control.
What is wrong or defect?
A: First check the internal batteries of the IR-Remote Control. When the LED quits a key stroke,
the IR-Remote Controller will be working. If the monitor don't reacts to the commands, re-
programme the operation code for the IR-Remote Controller. See chapter Set-up the IR-
Remote Controller.
Q: Using the GOLDEN EAGLE monitor together with a Sony BVE editor, i saw reflections on the
screen.
A: Under this circumstances you use a cable for the interconnection of poor quality. Check the
cable, specially the shield at the BVE side. No grounded shield is allowed. Specially for
longer distances ask your dealer or service to get the right cable.
© 02.07 TAMUZ - LCD Video Monitors HCM Series Broadcast Monitor
GOLDEN EAGLE
Page - 116 -