Submenu Brightness - TAMUZ HCM 112 Operation Manual

Main Menu

Submenu Brightness

Select the BRIGHTNESS MENU from the AUTO COLOR MENU with the UP and DOWN keys and open the
menu step with the PLUS (V+) key.
The BRIGHTNESS MENU shows following operational steps:
Auto Color
Probe Setup
Calibrate
Brightness
Measure
Status
x
y
Y cd/m 2
Whitepoint x
Whitepoint y
User Gamma
Close and save this menu step by pushing the MENU key once.
© 02.07 TAMUZ - LCD Video Monitors
2
Idle
0
0
0
307
321
Note: Any calibration should be done in a dark environment ( ~8 cd/m
the ITU, SMPTE or EBU recommendations.
Note: The BRIGHTNESS menu stops immediately when no probe is connected to the monitor
and indicates „ERROR" in the status field!
The OSD reacts slowly to commands, cause the system is searching for a probe!
Note: Under some circumstances the expected brightness value isn't available at the
measured monitor, may be to low or to high. In that case the lowest possible value will be
adjusted.
Note: LCD video monitors with a CCFL lamp backlight always reacts with a „post-roll". That
means, after setting a new value it takes some time to stabilize the backlight electronics for a
constant value. The automatic adjustment works slowly to compensate the „post-roll" effect.
Help
The brightness calibration is an automatically
process and starts with some white patterns to
measure the brightness of the specific monitor TFT
Panel. Thereafter it toggles between lower and higher
brightness values to adjust the setup value. The
brightness calibration may take about 2 to 5 minutes.
Indicates the measurement activity!
Only when „READY" is shown, the measurement is
finished and set.
HCM Series Broadcast Monitor
GOLDEN EAGLE
2 ) as recommended by
Page - 76 -