Video Input Buttons; Source Switch - TAMUZ HCM 112 Operation Manual

Operation

Video Input Buttons

As a default setup at the GOLDEN EAGLE series he button DOWN is configured as input switch for
direct access. After powering on, the monitor starts with the last configuration. To select another input
push the corresponding button.
Using the input switch DOWN when the main menu is not active, you may toggle between the input
sources, connected at the rear of the monitor HCM 1xx Golden Eagle Series. Depending of the moni-
tor type CCVS, YC, SDI, HDSDI or VGA signals may be the source.
See table hereafter for reference.
Model / Interface
Type
HCM 1xx VB
HCM 1xx DB
HCM 1xx DBD GOLDEN EAGLE DD
The list of selectable sources is programmable by the user. Therefore open the menu MENU - OTHER -
INPUT SELECTION and set the list as you like.
Note: The button for the input selection is programmable by the user.
If the source at the selected input port don't feed a signal into the monitor, an error message appears
on the screen. Check the cable connections or the feeding source itself.
If the source at the selected input port doesn't feed a signal into the monitor, an error message ap-
pears on the screen. Check the cable connections or the feeding source itself.

Source Switch

Using the button UP when the main menu is not active, you open the SOURCE menu and you can togg-
le directly between the available inputs at the HCM 1xx GOLDEN EAGLE series monitors.
Close the menu with the button MENU.
© 02.07 TAMUZ - LCD Video Monitors
Name
GOLDEN EAGLE PAL / NTSC / Secam
GOLDEN EAGLE D PAL / NTSC / Secam
PAL / NTSC / Secam
Format Input 1 Input 2
VGA VGA
VGA VGA
VGA RS232
HDTV
HCM Series Broadcast Monitor
GOLDEN EAGLE
Input 3 Input 4 Input 5 Input 6
CCVS CCVS YC
CCVS CCVS YC
CCVS CCVS YC
Input 7
- -
SDI -
SDI DVI
Page - 33 -