Switching The Monitor On; Power Save Mode - TAMUZ HCM 112 Operation Manual

Technical Data

Switching the Monitor on

Guarantee the connection with the external mains power at the rear ICE connector indicated as AC in-
put at the adapted power supply.
Prove if the DC plug is connected to the DC inlet.
For switching the display of the monitor GOLDEN EAGLE HCM 1xx series on: press the accompany-
ing switch POWER on the front.
The monitor starts test routines automatically and then represents the video on display.
The LED in the POWER switch illuminates, additionally the LEDs at the input selection illuminates in
the last selected setup; here SDI input A.
During the test routines the TAMUZ logo appears shortly on the screen after clearing the memory.
Thereafter the monitor shows the signal from the selected input source (refer to the manual chapter
Operation / Input Switch). If the source at this input port doesn't feed a signal into the monitor, an error
message appears on the screen.
Check the cable connections or the feeding source itself.

Power Save Mode

After a period of waiting (to refer the period length see chapter OSD menu / DPMS) for an incoming si-
gnal the monitor automatically switches to the POWER SAVE mode in two steps.
© 02.07 TAMUZ - LCD Video Monitors
Note: The video monitor GOLDEN EAGLE HCM 1xx series is equipped with an external
adapted universal power supply to work under any power circumstances.
HCM Series Broadcast Monitor
GOLDEN EAGLE
Page - 21 -