Switching The Monitor On - TAMUZ LSM 124W Operation Manual

Installation

Switching the Monitor on

Guarantee the connection with the external mains power at the rear ICE connector indicated as AC in-
put at the adapted power supply.
Prove if the DC plug is connected to the DC inlet.
For switching the display of the monitor SPARROWHAWK LSM 1xxW series on: press the accom-
panying switch POWER at the rear.
The monitor starts test routines automatically and then represents the video on display.
The LED in the POWER switch illuminates, additionally the LEDs at the input selection illuminates in
the last selected setup; here SDI input A.
During the test routines the TAMUZ logo appears shortly on the screen after clearing the memory.
Thereafter the monitor shows the signal from the selected input source (refer to the manual chapter
Operation / Input Switch). If the source at this input port doesn't feed a signal into the monitor, an error
message appears on the screen.
Check the cable connections or the feeding source itself.
© 02.07 TAMUZ - LCD Video Monitors
Note: The video monitor SPARROWHAWK LSM 1xxW series is equipped with an internal
universal power supply to work under any power circumstances.
LSM Digital Broadcast Monitor
SPARROWHAWK
Page - 21 -