Specifying The Part(S) To Which Multi-Effects Will Be; Adjusting The Delay Volume For Each Part Applied (Part Multi-Effects Switch) - Roland JX-305 Owner's Manual

Chapter 7. Applying Effects to the Sound (Effects)
Specifying the Part(s) to Which
Multi-Effects Will Be Applied
(Part Multi-Effects Switch)
Multi-effects can be switched on/off for each part.
1. Hold down [SHIFT] and press [MIXER].
The indicator will blink, and the Part Mixer page will
appear in the display.
2. Press PAGE [<] [>] several times to select
the "M-FX" page.
The display will graphically indicate the on/off status
of the Part Multi-Effects Switch for each part.
fig.0-36
Part
ON OFF RHY
3. Use the eight knobs of the REALTIME MODI-
FY section and the QUANTIZE section to set
the Part Multi-Effects Switch for each part.
Range:
OFF: Multi-effects will not be applied.
7
ON: Multi-effects will be applied.
RHY: The sound will be output according to the
Rhythm Tone Multi-Effects Switch, Rhythm
Tone Reverb Level, and Rhythm Tone Delay
Level settings of the currently selected rhythm
set (rhythm part only).
fig.3-17
1 2 3 4 5
REALTIME MODIFY
ENVELOPE ATTACK DECAY SUSTAIN
LFO 1 RATE FADE TIME PITCH DEPTH
EFFECTS REVERB LEVEL DELAY LEVEL MULTI CTRL1
* If the Multi-Effects Output Level setting is low, the
sound of the patch/rhythm set to which multi-effects is
applied will not be audible.
When you enter the Part Mixer page, all indicators of
[ENVELOPE/LFO1/EFFECTS], [FILTER/AMP/
PITCH] and [GRID/SHUFFLE/GROOVE] will blink,
and you can use the eight knobs of the REALTIME
MODIFY section and the QUANTIZE section to adjust
the settings of each part. At this time, the QUANTIZE
settings or REALTIME MODIFY cannot be modified
by the knobs.
124
Current Part
PART
6 7
QUANTIZE
RELEASE DEPTH FILTER CUTOFF RESONANCE GRID
FILTER DEPTH AMP DEPTH AMP LEVEL PANPOT SHUFFLE
MULTI CTRL 2 MULTI CTRL 3 PITCH PORTA TIME FINE TUNE GROOVE
4. Press [EXIT] to exit the Part Mixer page.
Volume (Multi-Effects Output Level)" (p. 106)
fig.7-56TEXT (#MC fig.4-66)
Multi effects sound
for all parts
If you wish to apply multi-effects or adjust the
reverb/delay volume for an individual rhythm tone,
select "RHY."
rhythm tones...
Level)" (p. 97)
rhythm tones...
Level)" (p. 98)
R
tone...
Effects Switch)" (p. 98)
TIMING
VELOCITY
"Adjusting the Overall Multi-Effects
For each rhythm tone
Part 1–7
For each part
Entire rhythm part
ON OFF ON RHY
MULTI CTRL3
Multi effects sound
To adjust the reverb volume for individual
"R.TONE Rev Level (Rhythm Tone Reverb
To adjust the delay volume for individual
"R.TONE Dly Level (Rhythm Tone Delay
To turn multi-effects on/off for each rhythm
"R.TONE M-FX SW (Rhythm Tone Multi-
OFF
Dry sound