Operation - Hitachi BD-W3300 Instruction Manual

Symptoms
Did you press Pause button during spinning operation?
Door can not be opened until the tumbling drum has stopped
rotating.
Did you turn off the power supply during drying operation?
Door will remain locked and can not be opened until the
temperature inside the tumbling drum reduces.
HIGH
Is blinking?
When the temperature inside the tumbling drum has increased
due to drying operation or warm air spinning, cooling operation is
performed to reduce the temperature inside the tumbling drum.
Door can not be
opened Has [CHILD LOCK] been set?
Even if the power supply is automatically turned off after the
completion of the operation with the child lock activated, door
can not be opened as child lock is still active.
Is there any water in the tumbling drum?
Door lock may not be released depending on the water level
during operation.
Is the air blowing?
Although it is paused during the air blowing operation, the
door can't be opened until the air blowing stops.
Does the time left indicator blink [0:00]?
Soft Guard is on.
Door does not open
easily as the door
open button is not
In some cases, the door bellow may stick with the door.
operating smoothly
Is the part of door lock blocked by any foreign object?
The door can't be
closed
Has the door stopper (door open screw) come out?
Although using the
machine for the first
It is the moisture remaining from the drying test at factory,
time, drum and drain
which is condensed due to outdoor temperature.
hose are wet.
Water or the components of the detergent is adhered to the
The tumbling drum
tumbling drum, causing oxide film.
discolors
Please check the following items Adjustment method
Wait until the tumbling drum stops completely.
Press power ON button and wait until the temperature inside the
tumbling drum reduces.
HIGH
When this indicator lights up, the door can be opened.
HIGH
Wait until the temperature inside the tumbling drum reduces.
When this indicator lights up, the door can be opened.
Release the child lock.
Please perform the spinning operation and water drainage.
Wait until the air blow stops.
Pressing the Pause button will release the door lock. For setting
and releasing Soft Guard
It is not an error.
Keeping the Open Door button pressed, open the door by pulling
the door surrounding (concaved portion) near the button.
Clean off the foreign object. Press the [START] button only when
the washing machine door is properly closed.
Restore the door stopper (door open screw) to its original
position.
It is not an error.
Please wipe it off with the commercially available special cleaner if
you worry about it.
HIGH
85