Hitachi BD-W3300 Instruction Manual page 74

Maintenance
Drying filter
(Continued)
Reinstall the dried screen to its original position
The center of the screen B is aligned to the shaft of the dried screen body to install it
vertically.
Fix the dry filter securely. If it is not fixed in place, steam or water leakage or noise (from the drying fan) may be caused.
If the operation continues when the dry filter blockage indicator and [C06] are blinking, it may lead to errors such as [Long drying time], [Poor drying] and [The power
is turned off during operation when the laundry is not dried fully].
Gently wash the dry filter with your hands. Do not use the detergent or bleach for washing.
After installation, press the [START] button, the indicator of [Dry filter] and [C06] turn off.
After washing the Drying Filter, it will be displayed again after the Washing-Drying or Drying operation are run more than 25 times. (This will be displayed even if there
is not much accumulated thread debris.)
Request
The dry filter is considered as wear & tear item. In case that the filter is torn breakage of the filter, purchase it from the service center or dealer.
Insertion socket for the dry filter
The dry filter indication may not go off in some cases, leading to the error [C06].
The reason may be that the fitting position of the dry filter is adhered with lint.
In such a case, use the accessory suction nozzle to clean it off.
Press to turn the power on
Press for 3 or more seconds
——— will be displayed at the place where the remaining time is displayed, and the
Eco Lamp (P.4)
Install the suction nozzle to the sucking part of the cleaner
To inhale any lint adhering to the rear filter
Clean off any lint adhering to the top and bottom inside of screen inlet.
If the inlet nozzle does fit the vacuum cleaner inlet nozzle (loose), do the following according to the vacuum cleaner you are using.
For a Hitachi product
For non-Hitachi product
Perform maintenance while the dry filter is dried.
It is to prevent failure of the cleaner due to moisture contained in lint.
Do not place your hand or finger into the rear filter.
You may be injured because it is narrow inside.
74
(Continued)
will be turned off, and the machine will go Auto-Off.
: Attach the attachment (vacuum cleaner attachment) to the vacuum cleaner
: Attach by wrapping tape around the inlet nozzle.
When screen B is removed at maintenance
Suction nozzle
The drying filter connection port
Filter B
Shaft