Hitachi BD-W3300 Instruction Manual page 72

Maintenance
Lint filter
(Continued)
Putting back the thread debris filter
Properly pull on the two grips.
If the thread debris filter comes out, align the thread debris filter with the slot it
goes into and push it in vertically.
Place the lint filter with the [UP] mark on the screen part
facing up.
Check & make sure that the rubber gasket in the lint filter does not come off.
Check & make sure that no lint is stuck to the fitting position or rubber gasket of
the lint filter.
Put the thread debris filter in
Insert the lint filter all the way.
Set the knob rightwards until a click is heard.
If the knob is not set rightwards to the position where a click is heard. The error [C16] will be
indicated, leading to failure to operate.
Close the lint filter cover.
Do not remove the rubber gasket
There may be water leakage without it.
Check the rubber gasket & make sure that there's no lint stuck to it when installing the lint filter.
There is the risk of water leakage if lint is stuck to it when the filter is installed.
Immediately replace any damaged lint filter or rubber gasket.
Otherwise water leakage or failure may be caused.
Fix the lint filter securely. If it is not fixed, error [C16] will display and cannot operate.
72
(Continued)
Insert it
If the debris filter cover comes off during cleaning
Rubber buffering
Please set the knob right-
wards until a click is heard.
Nail
Shaft
Filter part
The [UP] mark
Knob
Knob