Table of Contents
Advertisement
Preparation and putting method of detergent and softener
Washing load detection and detergent amount indication
After putting in the laundry, set the desired program and press [START] button
The tumbling drum rotates and the sensor detects the washing load
When there is 3 L or more of water in the tumbling drum, or in the program of
[DELICATE], [BLANKET], [TUB CLEAN] or [TUB DRY], it will not display the
detected washing load and the detergent amount (approximately).
Detergent amount is indicated (FUZZY)
The time left indication is started after about 6 sec. (FUZZY) (The detergent cup display
details will not change)
Indication example 1 HR. 30 MIN.
Pull out the detergent case, and put in the detergent, bleach and
softener by referring to the right table.
Water will be fed after the detergent amount is indicated for about 1 min. Press the blinking
PROGRAM button (
If it is not possible to add it within one minute, press the Pause button. It will not be possible
to add detergent.
UV Cut, UV Cut Whitening, and Care Vale cannot be used because they result in too much bubbles. Using these may result in adverse effects
Detergent
(water leakage or electric shocks).
Powdered soaps (natural fats) cannot be used. It may block the piping of the machine and case malfunction or water leakage.
Use lower amounts of detergents that create a lot of bubbles, such as Bold and Ariel, at 20g for 30L of water.
For the program other than [TUB CLEAN], do not use chlorine bleach.
Bleach
Only use a small amount of Lenor Deodorizing Softener
Softener
Using a large amount may result in blockages or staining of washing.
26
Indication of detection in process
Example of display: 30 minutes
or
). Water will be fed in immediately.
Points to note regarding detergent, bleach, and softener
[Examples of Displays]
MADE IN JAPAN
Washing load
Detergent amount
(Approximately)
indication
6-9kg
4-6kg
1-4kg
-1kg
STATIC DRY
(Cup 1.0)
(Cup 0.8)
(Cup 0.6)
(Cup 0.3)
Hide quick links:
Advertisement
Table of Contents
