Lighting Instructions; 138090_Rev_F - Jøtul GF 600 DV II Firelight Installation And Operation Instructions Manual

IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION
MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
A. This appliance has a pilot which must be lit by hand.
When lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING, smell all around the appliance area
for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle to the
floor.
WHAT TO DO IF YOU SMELL GAS:
• Extinguish any open flame.
• Open windows.
• Do not light any appliance.
• Do not touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's
phone.
1. STOP! Read the safety information above.
2. Access the valve controls in the left side compartment.
3. Turn the Burner ON/OFF switch to "OFF", or set the ther-
mostat to the lowest setting (if used).
4. Confirm that the gas supply line shut-off valve is open.
5. Push in gas control knob slightly and turn clockwise
to "OFF".
Control
Knob
NOTE: Knob cannot be turned from "PILOT" to "OFF"
unless the knob is pushed in slightly. Do not force.
6. Wait five (5) minutes to clear out any gas. If you then
smell gas, STOP! Follow "B" in the safety information
above on this page. If you do not smell gas, go to the
next step.
7. Push in gas control knob slightly and turn counter-
clockwise to "PILOT".
1. Turn ON/OFF switch to" OFF". The pilot will remain lit for
normal service.
2. For complete shutdown, turn ON/OFF switch to "OFF".

LIGHTING INSTRUCTIONS

FOR YOUR SAFETY, READ BEFORE LIGHTING.
LIGHTING INSTRUCTIONS
Control Valve
TO TURN OFF GAS TO THE APPLIANCE:
WARNING:
• If your gas supplier cannot be reached, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, do not try to repair it. Call a qualified
technician. Force or attempted repair may result in a
fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of
the control system and any gas control which has
been under water.
8. Push in control knob all the way and hold in. Imme-
diately light the pilot by triggering the spark ignitor
(push the red button repeatedly)
until pilot lights. Continue to
hold the control knob in for
about one minute after the
pilot lights. Release knob and
it should spring back. The pilot
should remain lit. If it goes
out, repeat Steps 5 through 8.
• If knob does not return when released, stop
and immediately call your service technician or gas
supplier.
• If pilot will not stay lit after several attempts, turn
the control knob to OFF and call your service techni-
cian or gas supplier.
9. Turn gas control knob counterclockwise
10. Set the Burner switch to "ON" to light the burner.
If using a thermostat, set Burner switch to "T-STAT"
and set the thermostat to the desired temperature.
3. Access the lower controls.
4. Depress gas control knob slightly and turn clock-
wise to "OFF". Do not force.

138090_Rev_F

7.29.10
Pilot Assembly
to "ON".
31