Jøtul GF 600 DV II Firelight Installation And Operation Instructions Manual page 15

5. Remove the wingnut and fender washer from the
Air Shutter stem, located under the stove, directly
behind the valve. See fig. 17.
6. Pull the Burner Plate forward to disengage it and
the Air Shutter from the burner orifice and lift it
out of the firebox.
7. Change the main burner orifice. Using a ½" open
end wrench or deep-well socket, remove the
burner orifice from the brass orifice holder. Re-
place with the orifice supplied in the kit. Tighten
securely.
8. Change the Pilot Orifice. From within the fire-
box, pull the pilot hood off the pilot assembly.
See Fig. 18. Using the 4 mm allen wrench included
with the conversion kit, remove the original pilot
orifice (counterclockwise).
Replace with the appropriate orifice:
#51 for natural gas
#30 for propane
9. Tighten orifice into the base of the pilot assembly.
Be sure the orifice is tightly secured to prevent
bypass leakage. Replace pilot hood onto the pilot
assembly.
10. Replace the Air Shutter over the burner orifice.
Note that NG/LP designations are stamped on
the sides of the shutter. Orient the shutter so
that the appropriate fuel designation is on the
right, facing the pilot assembly. See fig. 17a.
11. Reinstall the Burner Plate by engaging the tube
with the Air Shutter. BE CERTAIN THE BURNER IS
LEVEL AND SECURELY SEATED ON THE SUPPORT
LEGS ON THE FIREBOX FLOOR.
12. Replace the fender washer and wingnut on the
Air Shutter stem under the firebox. Secure loosely
for adjustment later.
13. Replace the Rear Wall Skirt and Burner Skirt.
14. Replace the variable regulator. Using a Torx T-20
screwdriver, remove the three specialty screws
from the HI/LO regulator on the front of the
valve. Note: To help identify which screws to
remove, refer to the new regulator in the kit. See
Figure 19.
15. Remove the regulator tower and the gasket.
Be sure to remove the black rubber gasket from
the valve.
16. Install the new variable regulator tower from the
kit. Be sure that the gasket is properly positioned
and tighten screws securely.
NEVER USE AN OPEN FLAME TO CHECK FOR GAS
LEAKS.
It is important that the correct gas pressure be estab-
lished at the time of installation. For more details see
the Gas Pressure section of this manual (page 13).
ALWAYS REFER TO THE LIGHTING
INSTRUCTIONS ON THE INSIDE BACK COVER OF THIS
MANUAL WHEN LIGHTING THE STOVE.
Burner
Orifice
Figure 16a. Burner orifice and pilot assembly locations.
OPEN
Open
Figure 17. Remove the Air Shutter wingnut and fender
washer.
Figure 17a.
Replace the Air Shutter.
Pilot Head
Pilot Orifice
Figure 18.
Remove pilot head
and pilot orifice.
138090_Rev_F 7.29.10
Pilot As-
sembly
CLOSE
Close
Air Shutter
Wingnut
NOTICE: Appropriate fuel des-
ignation should face the right
side of the shutter.
15