Jøtul GF 600 DV II Firelight Installation And Operation Instructions Manual page 18

138090_Rev_F 7.29.10
Install the Log Set
The six-piece log set is packaged inside the firebox. It
includes a bag of ember stones that simulate glow-
ing coals when the burner is operating.
Do not handle the log set with your bare hands.
Always wear gloves to prevent skin irritation from
the ceramic fibers.
1. Install the Log Set and Ember Stones as shown in
figures 23-28.
2. Replace the Glass Frame.
Slide the glass frame back down against the front
of the firebox until it is securely seated at the bot-
tom. Pull the latches forward to engage with the
notches in upper frame rail.
3. Replace the Top Plate and Grille.
Figure 23.
Install Right
Log on pins.
Figure 24 .
Install Rear
Log on pins.
#220993
Figure 25 .
Install Left Log
on pins.
18
#220994
#220992
#220995
Figure 26.
Left Middle Log rests on pins.
Right Middle Log rests in place.
#220701
Figure 27 .
Engage the Top Log with the pin in the
Rear Log and rest the lower end over the
Left Middle Log.
Pilot Assembly
Figure 28.
Loosely spread the
Ember Stones over
the burner plate. Take
care to keep ember
stones off of the pilot
carry-over ports and
away from the Pilot
Assembly.
#221105
Carry-over Ports