Table of Contents
Advertisement
Installation and Setup
Preparation for Camera Installation
Step1. Removing the Dome Bubble and Turret
Step 2. Removing the Gimbal
20
1.
Using the supplied Allen key, loosen the captive screws on the dome bubble (see
Figure 2-1
on
page
19). Remove the dome bubble and set it aside.
2.
Gently pull the turret off the gimbal assembly, then set it aside.
To gain better access to the mounting holes and the wiring board, remove the gimbal from
the enclosure base.
1.
Squeeze the four black tabs until they are free of the black clips.
2.
Elevate the hinge until the gimbal is above the housing and you have access to the
camera board connections and mounting holes.
Figure 2-2
Mounting Holes and Removed Gimbal
Metal
hinge
Mounting
holes
Black tabs (x4)
Black clips (x4)
Caution
When elevating the hinge,
do not overstress the two
ribbon cables. If
necessary, rotate the
gimbal to provide
additional slack.
Hide quick links:
Advertisement
Table of Contents
