Calling Up The Map Display; Structure Of The Map Display; Map Display Without Route Guidance; Map Display With Route Guidance - Becker Map Pilot Operating Manual

Calling up the map display

The map display is called up automatical-
ly when you start route guidance.
Without route guidance, you can call up
the map display using the main menu or
by pressing and holding down button
L in the main menus.
> Select from the main menu.
Map
The map display will then appear and, if
GPS reception is available, will show your
current position.
If route guidance is already active, the
map will be displayed with route guid-
ance.

Structure of the map display

The structure depends on the settings
made in "Map display" on page 42 and
whether route guidance is active or not.

Map display without route guidance

3
4
If the navigation is not active, almost the
whole area of the display will be taken up
by the map.
Speed limit on the road currently be-
1
ing driven on (display not available
for all roads), signs for the driver
alerts will also be displayed
Number of satellites currently being
2
received
Vehicle position
3
Current road
4

Map display with route guidance

Note:
The information in the left area is only
displayed when action must be taken.
Otherwise the destination arrival time -
and stopover arrival time, if applicable - is
displayed in the lower left area.
1
10
9
2
8
7
Road signs, which you should follow
1
Speed limit on the road currently be-
2
ing driven on (display not available
for all roads)
Driver alerts
3
Number of satellites currently being
4
received
Display of TMC status
5
Vehicle position
6
NAVIGATION MODE
1
2
3
6
4
5
>>>
> EN
34