Block A Route Section - Becker Map Pilot Operating Manual

Display route list
You can have the route displayed on a list.
> When the entire route is displayed,
select .
Route list
The route list is displayed.
Set route options.
You can set the route options.
> When the entire route is displayed,
select .
Options
> Select
.
Route options
> Configure
the route
described under "Route options" on
page 45.
After any modification, the route will be
recalculated.
Simulate route
You can start a simulation of the route.
> When the entire route is displayed,
select
Options
> Select
Simulation
The route is simulated at four times the
usual speed.
By pressing the
brought to the next action event.
By pressing the
simulation is stopped.
options as

Block a route section

You can block a section of the route
ahead. You thereby set specific sections
. that should not be driven. From Becker®
. MAP PILOT, a detour calculation will be
attempted.
button you are
C
L button, the
> In the route menu, select
NAVIGATION MODE
Note:
• Destination navigation is stopped
during section selection.
• The maximum length of a section is 50
km (31 mi)
• During the section selection, you can
go back to the current point by
L
pressing the button.
Block ahead
>>>
> EN
.
40