Displaying Position - Becker Map Pilot Operating Manual

>>> NAVIGATION MODE
> With the 3D display, by selecting
you can select whether you
> EN
Objects
would like to see 3D attractions (
not ( ). At the same time, the
building display is turned on/off.
> With the 2D display, by selecting
you can select whether you
Heading up
would like the map displayed facing the
trip direction (
( ).
> With Autozoom, you can turn the
autozoom on
> During the 3D display, select
to change the angle of the map.
angle
> Select one of the following angles:
,
Higher Normal
> Save and close your settings by pressing
the L button.
43

Displaying position

3D-
You can display your current position and
) or
then store it. You can also display
information on the current GPS reception
status.
> In the map toolbox, select
) or facing North
or off .
Map tilt
The current position is displayed. An
address is displayed whenever possible.
The geocoordinates are displayed if no
address is available for the current
location.
During active navigation, the destination
address and potential stopovers are
displayed.
and .
You can switch back to the map by
Lower
selecting
destination navigation is active) or
to map
Press the
options.
Information
(when
Resume guidance
Return
.
&
button for more control
You can save the actual position of the last
targets by selecting .
Save
GPS reception information is displayed
by selecting .
GPS-Info
.
You can see how many satellites can be
linked to and if satellite reception is
sufficient for navigation. The current time
and geolocation is also displayed.