How To Ensure Your Fireplace Cannot Be Turned On Inadvertently - Valor Portrait 530ILN Installation & Owner's Manual

OWNER'S
INFORMATION
Lighting, Operation and Rating Information
WARNING
!
DO NOT ATTEMPT TO TOUCH THE DATA PLATE
WHILE THE FIREPLACE IS STILL HOT! Let the
 replace cool  rst before touching it.
The Lighting, Operation and Rating information is
located on a plate under the  rebox.
To access the plate, remove any fret or access panel
and grab the plate and slide it out to read it. There is
important information on both sides of the plate.
Servicing
If your appliance require any attention, contact your
supplier quoting the model number. It will be helpful if
the appliance serial number can also be quoted. This is
on the rating plate located under the  rebox. The repair
parts are shown in the separate repair parts lea et.
Please always quote part number and description when
requesting spare parts.
Fireplace Control Devices
There are three ways to control your  replace.
1. Thermostatic Remote Control;
2. Wall Switch;
3. Manual On/Off Switch.
The manual On/Off switch must be ON for the  replace
to function. It can be used to shut off the  replace in
case of emergency——see above.
The Thermostatic Remote Control can be programmed
to function automatically——see pages 9––13.
The Wall Switch (optional) can be used to turn on, off
and to increase or decrease the  ame height——see
1265WSK——Wall Switch Kit.
NOTE: The remote control in the AUTO mode will
override the wall switch.
Thermostatic Remote
Wall Switch
Control
(optional)
8
Owner’' s Information
ON
OFF
Manual On/Off Switch
How to Turn Your Fireplace OFF (including pilot)
Familiarize yourself with each of these methods before
operating your  replace.
Handset and Wall Switch: Press and hold the OFF
button for a second (either on the handset or the wall
switch).
If the  ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
Remote control
handset
Manual ON/OFF Switch: Press the O button.
ON
OFF
Valve Switch
How to Ensure Your Fireplace Cannot
Be Turned ON Inadvertently
You can use one of the two following methods to
ensure that your  replace will not turn on when you
don’'t want it on.
First, ensure your fi replace is turned off—including
the pilot—and cold BEFORE going ahead.
•• You can prevent your  replace from lighting by
pressing the O button on the manual ON/OFF
switch on the gas valve——see image above.
•• Alternately, you can remove all batteries from the
receiver as well as the battery from the handset.
Automatic Shut-Off (in certain conditions)
Your  replace’' s remote control is equipped with an
automatic shut-off mechanism which is activated in
certain conditions. See page 13 in the Remote Control
Operation section for a description of this feature.
Wall Switch
(optional)
O