Valor Portrait 530ILN Installation & Owner's Manual page 12

OWNER'S
INFORMATION
SETTING PROGRAM TIMERS
•• You can program two periods of time between 12:00
am and 11:50 pm in each 24-hour cycle.
•• The Programs P1 and P2 must be set in the
following order during a 24-hour cycle:
P2 and P2 .
•• The icon indicates the beginning of the period (ON)
and the icon indicates the end of the period (OFF).
P1 P1 P2
•• If = or
is cancelled.
•• To keep the  replace ON all night, set
11:50 am and P1
Default settings:
P1
Program 1: 6:00 am
P2
Program 2: 11:50 pm
•• Brie y press SET button to scroll to
TIMER mode.
SETTING P1 ON TIME
•• Hold the SET button until
(sun) is displayed and the time
 ashes.
•• Press
set the hour.
•• Press
set the minutes.
12
Remote Control Operation
P1 , P1
= P2 , the programming
at
P2
at 12:00 am.
P1
8:00 am
P2
11:50 pm
P1
(large  ame) button to
(small  ame) button to
SETTING P1 OFF TIME
•• Brie y press SET button to scroll
,
•• Press
•• Press
SETTING P2 ON TIME
•• Brie y press SET to scroll to TIMER mode
(sun) while the time  ashes.
•• Follow the instructions given to set P1 ON time.
SETTING P2 OFF TIME
•• Brie y press SET to scroll to TIMER mode
(moon) while the time  ashes.
•• Follow the instructions given to set P1 OFF time.
Press OFF button to save these settings. The timers
are programmed. See the diagram on programming
sequences on the following page.
Tip
If you want to program only one period, program
and with desired times and program
P1
P2
with the same time as
to TIMER (moon) while the
P1
time  ashes.
(large  ame) button to set
the hour.
(small  ame) button to
set the minutes.
P2
P1
.
P2
P2
P1
and