Valor Portrait 530ILN Installation & Owner's Manual page 7

7. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
Safety warning plate
8. Reinstall the front and barrier screen.
WARNING
!
FOR SAFETY PURPOSE, ensure the barrier FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the fi replace front screen is re-installed on the fi replace front
after maintenance. after maintenance.
Checks
A periodic check of the pilot and burner  ames should
be made. Check after the  re has been on for at least
30 minutes. The pilot  ame must cover the tip of the
thermocouple probe. The main burner  ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
With Logs
With Rocks
Correct fl ame appearance
Owner’' s Information
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
 ammable vapors and liquids. Inspect the vent terminal
outdoors regularly to make sure that dirt, snow, insects,
leaves, shrubs, trees do not obstruct it. Examine the
whole vent system regularly. We recommend annually.
Remote Control Handset Wall
Holder
Your  replace equipment includes a wall
holder to store the handset. If it hasn’'t be
installed, refer to the instructions further
on in this manual for the installation.
Batteries
Low battery signal: see page 13.
BEFORE changing the batteries, turn off the valve
using the manual On/Off switch —see instructions on
next page.
The appliance uses four 1.5 V AA alkaline batteries for
its remote control receiver and one 9 V alkaline battery
for its handset. The batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off-season will extend the battery life. Should the
batteries loose power, the control may be operated by
manually turning the control knob at the valve or by
With Coals
turning off the valve at the switch.
To replace the batteries in the remote control
receiver:
1. The receiver is located to the left of the valve and it
Thermocouple
probe must be
in flame
2. Slide and remove the receiver cover.
3. Replace batteries with 4 AA alkaline batteries.
4. Replace the cover.
5. Put the receiver back in its position pushing it in so
WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the  replace cool  rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
is retained to the  rebox by a Velcro tab. Grab the
receiver and pull it out from its location.
it attaches to the Velcro tab.
OWNER'S
INFORMATION
7