Valor Portrait 530ILN Installation & Owner's Manual page 27

Conversion to Top Outlet for Solid Direct Vent
Co-axial Piping
If installing with rear vent outlet, go to next step.
1. Remove the top plate and seal by unscrewing
12 screws. Keep the seal, plate and screws for
 tting to the back.
2. Remove the rear outer vent collar and seal by
unscrewing 12 screws.
3. Remove the rear inner vent collar and seal by
unscrewing 8 screws.
4. To make sure that the collars are axially aligned,
 t the adapter 817VAK over the outer vent collar.
5. Position the inner collar and seal vertically inside the
top of the appliance. Drop the outer collar with adapter
over the inner collar to ensure alignment. Secure the
inner collar with 8 screws and the outer collar with
12 screws.
6. Fit the plate and seal (which was previously
removed from the top) to the back of the appliance
with 12 screws.
Appliance Preparation
QUALIFIED
INSTALLER
27