To Log Into The System Controller Using The Network Management Port - Fujitsu Sparc Enterprise T2000 Installation Manual

Status summary
VxDiag
POST
LOOPBACK
I2C
EPROM
FRU PROM
ETHERNET
MAIN CRC
BOOT CRC
TTYD
TTYC
MEMORY
MPC885
Please login:
▼ To Log Into the System Controller Using the
Network Management Port
Note – You must configure the system controller parameters shown in
Configure the System Controller Network Management Port" on page 39
can use the network management port.
1. Open a telnet session and connect to the system controller by specifying its
network address.
% telnet x.x.x.x.
Trying x.x.x.x ...
Connected to x.x.x.x.
Escape character is '^]'.
Copyright 2003 Sun Microsystems, Inc. All rights reserved.
Use is subject to license terms.
Sun(tm) Advanced Lights Out Manager 1.x
Please login:
- Status = 7FFF
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
- - PASSED
Chapter 3 Powering On the System
"To
before you
43