Tools And Equipment Needed; Optional Component Installation; Esd Precautions - Fujitsu Sparc Enterprise T2000 Installation Manual

Tools and Equipment Needed

In order to install the system, you must have the following tools:
#2 Phillips screwdriver
■
ESD mat and grounding strap
■
In addition, you must provide a system console device, such as one of the following:
ASCII terminal
■
Workstation
■
Terminal server
■
Patch panel connected to a terminal server
■

Optional Component Installation

The standard components of the server are installed at the factory. However, if you
ordered options such as additional memory or a PCI card, these will be shipped
separately. If possible, install these components prior to installing the server in a
rack.
If you ordered any options that are not factory-installed, see the SPARC Enterprise
T2000 Server Service Manual for installation instructions.
Note – The list of optional components can be updated without notice. See the web
site for the most current list of components supported in the server.

ESD Precautions

Electronic equipment is susceptible to damage by static electricity. Use a grounded
antistatic wriststrap, footstrap, or equivalent safety equipment to prevent
electrostatic damage (ESD) when you install or service the SPARC Enterprise T2000
server.
2 SPARC Enterprise T2000 Server Installation Guide • April 2007