74
Figure 21: Completing the table plate II
①
(1) – Screws
1. Place the control cabinet (2) on the underside of the table plate.
2. Screw the control cabinet (2) to the underside of the table plate
using 3 screws (1), washers, retaining rings and nuts.
8.3.4
Mounting the upper section support
Figure 22: Mounting the upper section support
①
②
(1) – Upper section support
1. Insert the upper section support (1) into the hole (2) in the table
plate.
(2) – Control cabinet
(2) – Hole
Operating Manual 512/532 Version 00.0 - 12/2013
Setup
②