Fitting The Upper Part Of The Sewing-Machine; Fitting The Angled Support And Fitting The Upper Part Of The Sewing Machine - DURKOPP ADLER 768 Setting Instructions Manual

5. Fitting the upper part of the sewing machine
5.1 Fit the angled support and mount the upper part of the
sewing machine
The minor components required to mount the upper part of the sewing machine will be
found in the special sewing machine's accessory pack.
–
Hammer upper-part support 5 into the hole in the table plate.
–
Insert the (M8) hexagonal nuts from below into the two holes 1 in the angled
support 8. The function of the hexagonal nuts is to secure the retaining plates 3.
–
Screw the angled support 8 to the table plate 9 with four (5.0x30) chipboard screws
(see sketch).
–
Press the hinge bases 2 into the recesses in the angled support.
–
Press the upper-part supports 10 into the recesses in the table plate 9.
–
Attach hinges 7 with (M6x8) countersunk screws to the base plate of the upper part
of the sewing machine.
–
Place the upper part of the sewing machine in the opening in the table plate.
The hinges 7 must be in the hinge bases 2.
–
Screw the retaining plates 3 to the angled support 8 with (M8x25) countersunk
screws.
–
Place the oil-return felt of the upper part of the sewing machine in the hollow of the
oil collector.
Caution!
The return hose must not be in contact with any moving parts.
CAUTION!
Do not rotate the upper part of the machine unless the
sewing foot is locked in the up position!
This will damage the sewing-foot lifting mechanism and the
table plate.
GB
9