DURKOPP ADLER 512 Operating Instructions Manual page 57

Settings via the software
Error message Description
E 5 1 0 Own seam
appearances file
error
E 5 1 1 USB write error
E 5 1 2 USB read error
E 5 1 3 USB write error
E 5 5 0 Data write error
E 5 5 1 Internal process
error
E 7 0 7 Motor signal
7 3 5 error
E 7 3 6 Motor rotation
error
E 7 3 7 Z phase error
E 7 3 8 Z phase error
E 9 0 7 X axis search
error
E 9 0 8 Y axis search
error
E 9 1 0 Clamp foot
search error
E 9 1 1 Clamp foot
motor error
Operating Manual 512/532 Version 00.0 - 12/2013
Possible cause
Read error U01 ~ U10
File with the same name
already present
Data cannot be loaded from
the USB stick
Data cannot be copied to the
USB stick.
Flash memory transfer error • Main power switch OFF.
Software error
Encoder / motor has no
signal
Motor stops after a certain
time / encoder has no signal
Z signal no longer changes
Z signal inaccurate / encoder
has no signal
X axis sensor not responding • Main power switch OFF.
Y axis sensor not responding • Main power switch OFF.
Clamp foot sensor not
responding
Clamp foot motor not
running correctly
Remedy
• Check the file type.
• Store the data anew on
the USB stick.
• Delete or rename the file.
• Check the USB stick.
• Plug in the USB stick
again.
• Check the USB stick.
• Plug in the USB stick
again.
• Repeat the procedure.
• Replace the mainboard.
• Main power switch OFF.
• Repeat the procedure.
• Replace the mainboard.
• Replace the software.
• Check the motor /
encoder.
• Check the motor /
encoder.
• Check the motor /
encoder.
• Check the motor /
encoder.
• Check the sensor.
• Check the sensor.
• Main power switch OFF.
• Check the sensor.
• Main power switch OFF.
• Check the motor and
connections.
55