Settings via the software
Operating Manual 512/532 Version 00.0 - 12/2013
5.22 Working with a USB stick
Up to 10 custom seam appearances can be loaded into the
controller via a USB stick.
Prerequisite:
• Machine is in programming mode, Ready button LED is off.
1. Plug the USB stick into the USB port on the controller.
The controller beeps briefly.
2. Press the USB button.
The button LED illuminates, the Program display shows
parameter number U01.
3. Press the +/– Program and select a memory location
(U01 ~ U10).
4. Press the Ready button.
The Function display shows values from 1 to 4:
• 1: Load seam appearance from USB stick.
• 2: Save seam appearance to USB stick.
• 3: Delete seam appearance from controller.
• 4: Edit seam appearance.
Loading a seam appearance into the controller from the
USB stick : Value 1
1. Use the +/– Function buttons to set a value of 1.
2. Press the Select button and select the desired seam
appearance file (HSR2000.csv ~ HSR2099.csv).
3. Press the Select button to load the seam appearance from
the USB stick.
The Function display shows the value ok,the controller
beeps and the seam appearance is now saved.
4. Press the Reset button twice.
51