Front Panel Programming Exercise - Elgar SW 5550AE Operation Manual

Operation
3.5

Front Panel Programming Exercise

The following example illustrates programming the SW for a voltage dropout on a 120V
sine waveform that starts at 45° with a duration of 1 millisecond and an amplitude of 10
volts.
MAIN MENU
PROGRAM
MEASURE
WAVEFORM
SEQUENCE
INSTR
SYSTEM
1. At the MAIN MENU, select the WAVEFORM menu, then press <Enter>.
WAVEFORM
LOAD
EDIT
VIEW
SAVE
DELETE
2. The WAVEFORM Menu will default to the LOAD sub-menu. If the cursor is not
pointing to LOAD, use the Knob or Up/Down Arrow keys to select LOAD.
3. Press the Enter key to enter the FUNC (function) mode.
4. Press <Enter> again to place a box around the waveshape selection.
3-32
SW 5550AE • SW 3700AE • SW 1850AE
OUTPUT [OFF]
OUTPUT [OFF]
Operation Manual