Table 3-2 Self-Test Results Definitions - Elgar SW 5550AE Operation Manual

SW 5550AE • SW 3700AE • SW 1850AE
SYNC OUT selects the output sync signal to ON, OFF or EVENT. In the ON position,
the signal is driven by the output frequency of the waveform, or sequence settings. In
the EVENT position, a pulse will be generated for any change in VOLT, CURR, FREQ,
PHASE, or WAVEFORM.
The SYNC OUT setting only affects normal (non-sequence) mode. To set up the SW
so that a sync pulse only occurs for a specified sequence segment, set this parameter
to OFF. That way, before and after a sequence is run, no other sync pulses will occur.
Table 3–2 provides self-test result definitions.
BIT MEANING
0001 LCD Test
0002 EPROM CKSUM
0004 NVRAM BANK 0 CKSUM
0008 NVRAM BANK 1 CKSUM
0010 RAM Test
0020 VXI Test
0040 QSCI Test
0080 GPIB Test
Operation Manual
Table 3–2 SELF-TEST Results Definitions
BIT MEANING
0100 Battery Test
0200 QSPI Test
0400 DFI Test
0800 Speaker Test
1000 DWSB Self-Test 0
2000 DWSB Self-Test 1
4000 IWGB Self-Test 0
8000 IWGB Self-Test 1
Operation
3-23