Intel ® 440Gx Agpset Clocks; Ck100 - 100 Mhz Clock Synthesizer; Processor Frequency Select - Intel 440GX Design Manual

®
3.4 Intel
3.4.1

CK100 - 100 MHz Clock Synthesizer

•
The system clock which provides 100 MHz to the processor and the Intel
and the clocks for the APIC must be +2.5V.
•
If implemented in the clock chip, pin 28, when strapped low, provides a spread spectrum
modulation effect which may help reduce EMI. The modulation will be "down spread" only,
meaning that the nominal 100/66 MHz frequencies will be modulated 0.25% to 0.5% below
100/66. While this may help EMI testing, performance will be impacted. Check with your
clock vendor for availability of this feature.
•
SEL pins on CK100 can be used to select special functionality using 8.2K ohm pull-ups to V
Table 3-3. Processor Frequency Select
SEL100/66#
•
Unused clocks should be terminated to ground with 22 ohm resistors.
•
22 ohm series resistors are recommended on the CPU, PCI, and IOAPIC clock outputs.
•
In a UP system, clock skew between the 82443GX and the CPU can be reduced by tying the
clock driver pins together at the clock chip and driving the CPU and 82443GX from this net
with a 10 Ohm resistor at the driver for each.
•
10K ohm pull-ups to VCC
POS is not supported, connecting these signals to the PIIX4E is not required. On reset, SUSA#
(connected to PWRDWN#) is asserted, which causes the clock outputs to stop. This may cause
problems with the ITP when connected. Zero ohm stuffing options can be used to select the
functionality.
•
Check with your clock vendor and the reference schematics for special layout and decoupling
considerations. The reference schematics implement an LC filter on the supply pins to reduce
noise.
®
Intel 440GX AGPset Design Guide
440GX AGPset Clocks
SEL1
0 0
1 0
0 1
1 1
are recommended on PCI_STP#, CPU_STP#, PWRDWN#. If
3.3
Design Checklist
®
440GX AGPset,
SEL0 Function
0 Tri-state
0 Test Mode
1 Active 66MHz
1 Active 100MHz
3-8